The BH-1000 board holder consists of posts and rails and is a highly flexible system. It has two sets of post-rail assemblies (two posts, one rail per assembly). Two sliding clips are mounted on each rail and require minimal board-edge space to clamp the board. The post-rail assemblies can be located as close as 12 mm (1/2") to virtually any distance apart. Additionally, each post-rail system can be converted to a stand-alone post-pin configuration with removal of the rails and by adding the threaded pins. These pins can be used for holding board tooling holes or for board support.

Metcal BH-1000 Post Rail Board Holder System Highlights:

• The Metcal desoldering, rework, soldering board holder kit is another quality product from Metcal
• It has two sets of post-rail assemblies (two posts, one rail per assembly)
• Two sliding clips are mounted on each rail and require minimal board-edge space to clamp the board
• The post-rail assemblies can be located as close as 12 mm (1/2") to virtually any distance apart
• These pins can be used for holding board tooling holes or for board support

Metcal BH-1000 Post Rail Board Holder System Specs:

• Brand: Metcal
• SKU: BH-1000
• Height: 5.0 in
• Length: 14.0 in
• Width: 8.0 in
• For Use With: PCT-100 Focused Convection Pre-Heater